How To Apply Crystal Serum Light:

1.) Thoroughly clean the surface using Panel Wipe

2.) Spray panel wipe into a GtechniQ MF1 Microfibre Cloth and wipe down each panel

3.) Shake well and wear gloves

4.) Soak the application pad with 3 full measures of CSL from the pipette and work the liquid into the pad to get an even saturation

5.) Add in overlapping strokes to an area roughly 2ft x 2ft 

6.) Immediately remove residue with an MF1 cloth

7.) Take a second microfiber and remove any excess residue

8.) Inspect the area for any remaining residue and remove with a MF1 Cloth

9.) Allow the coating to cure for 2 hours before exposing the car to the elements. Do NOT wash for the first 7 days

How To Apply EXO:

1.) Spray Panel Wipe onto a GtechniQ MF1 Microfibre Cloth and wipe down each panel in small sections

2.) Shake well and wear gloves

3.) Prime the AP2 Ultra Soft Applicator evenly so that the pad is saturated

4.) Add in overlapping strokes to an area roughly 2ft x 2ft 

5.) Wait for 1 to 2 minutes after applying to a panel and buff with an MF1

6.) Take a second microfibre and remove any excess residue

7.) Inspect the area for any remaining residue and remove with a MF1 Microfibre Cloth

8.) Allow the coating to cure for 12 hours before exposing the car to the elements. Do NOT wash for the first 7 days

* If applied to bare paint prepare surface using Panel Wipe if applied over another coating do not use Panel Wipe but leave CSL and CSU 1 hour and C1 4 hours before applying EXO